Siemens SCALANCE W760 - Show Events Faults Status

Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
406 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
show events faults config [{link}]
The parameters have the following meaning:
Parameter
Description
link
Monitoring of the network connections for a change in the connection
status.
If no parameters are specified, the settings for error monitoring are displayed.
Result
The current configuration of the selected error monitoring function is displayed.
11.1.5
show events faults status
Description
This command shows the status messages of fault monitoring of the power supply and
network connections.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events faults status
Result
A table with the status messages of the error monitoring functions is displayed.