Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
69
The file types are displayed or the file type is assigned a name.
With this command, you load a file from a TFTP server into the file system of the device. The
TFTP protocol is used for the transfer. You can also display a list of available files.
● The name of the file is specified
● You are in the LOADSAVE Configuration mode.
The command prompt is:
cli(config-loadsave)#
Call up the command with the following parameters:
tftp load{showfiles|filetype<filetype>}
The parameters have the following meaning:
Shows the available files
Keyword for a file type to be loaded -
The file types are displayed or the file is downloaded to the device.
You configure the name of the file with the tftp filename command.
To Next Page
Loading...
Need help?
General
