Siemens SCALANCE W760 - Clear Wlan Statistics; Commands in the Global Configuration Mode

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
135
6.1.2
clear wlan statistics
Description
With this command, you reset the WLAN statistics.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
clear wlan statistics
Result
The WLAN statistics are reset.
Further notes
You display the WLAN statistics tables with the show wlan statistics command.
6.1.3
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.