Siemens SCALANCE W760 - Show Wlan Allowed Channels

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
118 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The following settings are displayed:
● RTS/CTS threshold
● Fragmentation length threshold
● HW retries
In Access Point mode, the following additional settings are displayed:
● Beacon interval
● DTIM
● Force roaming on link down
● Overlap AP aging interval
6.1.1.2
show wlan allowed channels
Description
This command displays the available wireless channels. If you have selected channels
explicitly for wireless communication, this information is also displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan allowed channels <wlan 0/X>
The parameter has the following meaning:
Parameter
Description
Values or range of values
wlan 0/X
WLAN interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The list of wireless channels available for establishing a wireless link to the relevant WLAN
interface is displayed.