Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
159
wlan client mac address (client)
Description
With this command, you specify the MAC address of the client.
Note
This command is only available in the client mode.
● The MAC address is assigned to the client manually.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan client mac address <mac address>
The parameter has the following meaning:
Values or range of values
MAC address of the client
The MAC address was assigned to the client.
You display the setting with the show wlan client <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
