Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
191
no vap wds only (access point)
Description
With this command, you specify that the access point supports not only communication via
WDS. This setting is activated as default.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
no vap wds only
You have specified who the VAP interface connects to.
You display the setting with the show wlan vap <vap X 0/Y>command.
You enable the function with the
vap wds only command.
vap wds only (access point) (Page 190)
To Next Page
Loading...
Need help?
General
