Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
42 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call the command without parameters:
show versions
The following settings are displayed:
● Basic device
● Name
● Revision
● Order ID
● Firmware
● Bootloader
● Description
● Version
● Date
clear counters
Description
With this command, you reset the counters of an interface.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
To Next Page
Loading...
Need help?
General
