Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
248 Configuration Manual, 11/2014, C79000-G8976-C351-03
You can display the status of this function and other information with the show spanning tree
interface
command with the detail option.
spanning-tree bpdu-transmit
Description
With this command, you enable or disable the BPDU transmit status at the port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
BPDU packets are transmitted at the
Default: enabled
BPDU packets are not transmitted at
the port
-
The BPDU transmit status has switched over.
You can display the status of this function and other information with the show spanning tree
interface
command with the detail option.
To Next Page
Loading...
Need help?
General
