Siemens SCALANCE W760 - Show Events Config; Show Events Severity

Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
404 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call the command without parameters:
show authlog
Result
The content of the logbook is displayed.
11.1.2
show events config
Description
This command shows the current configuration for forwarding the messages of the various
event types.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events config
Result
The current configuration of the events display is displayed.
11.1.3
show events severity
Description
This command shows the degree of severity of an event ("Info", "Warning" or "Critical")
starting at which a notification (sending of an e-mail, entry in the Syslog table, entry in the
Syslog file) is generated.