Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
261
The parameters have the following meaning:
shows the information for a specific IP address enter a valid IP ad-
defines an address range using the subnet mask /8, /16 or /24
Shows the direct connections
Shows the static connections -
The routing table is displayed.
show ip telnet
Description
This command shows the admin status and the port number of the Telnet server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip telnet
The admin status and the port number of the Telnet server are displayed.
To Next Page
Loading...
Need help?
General
