Siemens SCALANCE W760 - No Spanning-Tree Auto-Edge; Spanning-Tree Bdpufilter

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
246 Configuration Manual, 11/2014, C79000-G8976-C351-03
Further notes
The automatic discovery of a bridge on the interface is enabled with the no spanning-tree
auto-edge
command.
6.3.4.4
no spanning-tree auto-edge
Description
With this command, you disable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the spanning-tree
auto-edge
command.
6.3.4.5
spanning-tree bdpufilter
Description
With this command, you configure the BPDU transmit status for a port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#