Siemens SCALANCE W760 - Show Ip Dns; Show Ip Dns Cache

Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
262 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.1.1.5
show ip dns
Description
This command shows information about the DNS client, for example the status of the DNS
client and parameters for querying the DNS server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dns
Result
Information on the DNS client is displayed.
7.1.1.6
show ip dns cache
Description
This command shows the content of the DNS cache. The DNS cache buffers replies of the
DNS server for a brief time. This allows other queries for the same name to be replied to
directly without sending another query to the DNS server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dns cache
Result
The content of the DNS cache is displayed.