Siemens SCALANCE W760 - Show Snmp Targetaddr; Show Snmp Targetparam

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
305
Syntax
Call the command without parameters:
show snmp notif
Result
The configured SNMP notification types are displayed.
7.4.1.9
show snmp targetaddr
Description
This command shows the configured SNMP target addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetaddr
Result
The configured SNMP target addresses are displayed.
7.4.1.10
show snmp targetparam
Description
This command shows the configured SNMP target parameters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#