Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
72 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
password {showfiles|filetype<filetype>[pw<password>]}
The parameters have the following meaning:
Shows the available files
Shows that the file type follows that will be loaded
Keyword for the password -
Password Enter the password for
The password for the user certificate is configured and activated.
You disable the password with the no password command.
With this command, you disable the password for the user certificate.
Note
This command is only available in the client mode
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
To Next Page
Loading...
Need help?
General
