Siemens SCALANCE W760 - Commands in the WLAN Configuration Mode; Wlan Security Ap-Radius-Authenticator

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
363
Syntax
Call up the command with the following parameters:
show wlan security-keys < wlan 0/X >
The parameters have the following meaning:
Parameter
Description
Range of values / note
wlan 0/X
WLAN interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The key table is displayed.
10.2.4
Commands in the WLAN configuration mode
This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
10.2.4.1
wlan security ap-radius-authenticator
Description
With this command, you enable the RADIUS server.
Note
This command is available only in access point mod
e.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#