Siemens SCALANCE W760 Configuration Manual

Network protocols
7.9 SSH server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
343
Syntax
Call the command without parameters:
ssh-server
As default the function is "enabled".
Result
The SSH protocol is enabled on the device.
Further notes
You disable the SSH protocol with the no ssh-server command.
7.9.2.2
no ssh-server
Description
With this command, you disable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ssh-server
Result
The SSH protocol is disabled on the device.
Further notes
You enable the SSH protocol with the ssh-server command.

Siemens SCALANCE W760 Specifications

General

Product Type	Wireless Access Point
Frequency Bands	2.4 GHz, 5 GHz
Wireless Standards	IEEE 802.11a/b/g/n/ac
Number of Antennas	2
Power Supply	24 V DC
Operating Temperature	-20°C to +60°C
Operating Voltage	24 V DC
Protection Class	IP65
Antenna Connectors	R-SMA
Security	WPA2, WPA3