Broadcast Pix BPswitch - Adding Record Control to a Show

BPswitch Operators Manual
372 / 413
button.
Adding Record Control to a Show
Although you may control the Record from the Multi-View, it may be desired to use
the Control Panel or PixPad to control the stream. In order to do so you must add
the device to a show using one of the wildcard devices on the switcher.
1.
In BPswitcher, load the show to which you want to add record control. Select
the File, Load Show.
2.
Open PixMaster by selecting File, Edit Show.
3.
Click on Edit Show Settings and the Edit Show Settings window will open.
4.
Click on More Devices and the More Devices window will open, as shown
below.
5.
Select the desired wildcard device button to which you want to add record
control and a drop down menu will appear.
To select devices D-F or 4-6 select the View shifted devices checkbox.
6.
Click on Record, and it will appear on the PixButton, as shown below.
7.
Click on OK, to apply the Record Control the show, then Close in the Edit
Show Settings window and Save Show to apply all the settings.