Broadcast Pix BPswitch - Adding Camera Control to a Show

BPswitch Operators Manual
284 / 413
Note: This setting only functions
when the Telemetrics Camera
Control device is selected in the
Device Controls section.
10.
To save the settings, select the
Close button. In the System Settings
window, click on the OK button to
close the window.
Adding Camera Control to a Show
Once setup and installation is complete, you must now add the device to a show
using
one of the six wildcard devices on the switcher.
1.
In BP Switcher, load the show to which you want to add camera control.
Select the File, Load Show.
2.
Open PixMaster by selecting File, Edit Show.
3.
Click on Edit Show Settings and the Edit Show Settings window will open.
4.
Click on More Devices and the More Devices window will open, as shown
below.
5.
Select the desired wildcard device button to which you want to add camera
control and a drop down menu will appear.
To access devices D-F or 4-6 select the View shifted devices checkbox.
6.
Click on camera control, and it will appear on the PixButton, as shown
below.
7.
Click on OK, to apply the Camera Control the show, then Close in the Edit
Show Settings window and Save Show to apply all the settings.