BPswitch Operators Manual
256 / 413
The camera will reboot and about 10
seconds later the new IP address will be
set. Repeat these steps for each attached
camera
IP Configuration of Vaddio Cameras
The default IP address of IP controllable Vaddio cameras is 169.254.1.1. In order
to have the Broadcast Pix system control these cameras, the IP address must
change to be on the same subnet of the Broadcast Pix Server, either on the panel
or LAN networks. The IP settings of the Vaddio cameras are changed through a
web browser which can be run locally on the Broadcast Pix Server or on a remote
computer. For more information contact Vaddio directly: 1-800-572-2011.
To change the IP address of a Vaddio Camera:
Navigate to the Windows Control
Panel, Start Menu, Control Panel,
as shown on the right.
In the Windows Control Panel,
double-click the Network and
Sharing Center icon, as shown on
the right.
Note: These instructions follow a
Windows 7 Operating System.
In the Network and Sharing Center,
click on the ‘House Network’ link,
as shown on the right.
Note: This network may be
renamed, be sure to click on the
network that is not labeled
‘Broadcast Pix Control Panel’.
These steps assume that the
cameras are connected the LAN
port on the Server. If the Panel port
To Next Page
Loading...