CHAPTER 12: I/O Port
FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E 615
[bit5:4] RTO02E: RTO02 Output Select bits
Selects output for RTO02.
Reads out the register value.
Does not produce output for the waveform generator RTO02. [Initial value]
Uses RTO02_0 at the output pin of the waveform generator RTO02.
Uses RTO02_1 at the output pin of the waveform generator RTO02.
[bit3:2] RTO01E: RTO01 Output Select bits
Selects output for RTO01.
Reads out the register value.
Does not produce output for the waveform generator RTO01. [Initial value]
Uses RTO01_0 at the output pin of the waveform generator RTO01.
Uses RTO01_1 at the output pin of the waveform generator RTO01.
[bit1:0] RTO00E: RTO00 Output Select bits
Selects output for RTO00.
Reads out the register value.
Does not produce output for the waveform generator RTO00. [Initial value]
Uses RTO00_0 at the output pin of the waveform generator RTO00.
Uses RTO00_1 at the output pin of the waveform generator RTO00.
Note:
− This register is not initialized by deep standby transition reset.
To Next Page
Loading...
