CHAPTER 12: I/O Port
614 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
[bit17:16] DTTI0S: DTTI0X Input Select bits
Selects input for DTTI0X.
Reads out the register value.
Uses DTTI0X_0 at the input pin of the waveform generator DTTI0X. [Initial value]
Uses DTTI0X_1 at the input pin of the waveform generator DTTI0X.
Uses DTTI0X_2 at the input pin of the waveform generator DTTI0X.
[bit15:13] Reserved: Reserved bits
0b000 is read out from these bits.
When writing these bits, set them to 0b000.
[bit12] DTTI0C: DTTI0X Function Select bit
Selects a function for DTTI0X.
Reads out the register value.
Does not switch GPIO by DTTIF0 for output of pins RTO00 to RTO05. [Initial value]
Switches GPIO by DTTIF0 for output of pins RTO00 to RTO05.
[bit11:10] RTO05E: RTO05 Output Select bits
Selects output for RTO05.
Reads out the register value.
Does not produce output for the waveform generator RTO05. [Initial value]
Uses RTO05_0 at the output pin of the waveform generator RTO05.
Uses RTO05_1 at the output pin of the waveform generator RTO05.
[bit9:8] RTO04E: RTO04 Output Select bits
Selects output for RTO04.
Reads out the register value.
Does not produce output for the waveform generator RTO04. [Initial value]
Uses RTO04_0 at the output pin of the waveform generator RTO04.
Uses RTO04_1 at the output pin of the waveform generator RTO04.
[bit7:6] RTO03E: RTO03 Output Select bits
Selects output for RTO03.
Reads out the register value.
Does not produce output for the waveform generator RTO03. [Initial value]
Uses RTO03_0 at the output pin of the waveform generator RTO03.
Uses RTO03_1 at the output pin of the waveform generator RTO03.
To Next Page
Loading...
