CHAPTER 19: Programmable CRC
948 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
Prohibits the transfer request of input data for DMA.
In case that a transfer has been already requested, the transfer request will be canceled.
Allows the transfer request of input data for DMA.
Reads the register setting value.
Write access to this register is not allowed when CRC computing is performed
(PRGCRC_CFG.LOCK="1").
[bit27] Reserved bits
Writing has no effect in operation. Read value is always "0".
[bit28] LOCK(PRGCRC lock)
Indicates the CRC computing unit is in idle state.
Indicates writing to all registers is possible.
Indicates that the started CRC computing has been completed.
Indicates the CRC computing unit is in busy state.
Indicates writing to all registers is ignored.
Indicates that the started CRC computing has not been completed.
[bit31:29] Reserved bits
Writing has no effect in operation. Read value is always "0".
To Next Page
Loading...
