PORTx_PCRn field descriptions (continued)
Field Description
0 Passive input filter is disabled on the corresponding pin.
1 Passive input filter is enabled on the corresponding pin, if the pin is configured as a digital input. Refer
to the device data sheet for filter characteristics.
3
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
2
SRE
Slew Rate Enable
This bit is read only for pins that do not support a configurable slew rate.
Slew rate configuration is valid in all digital pin muxing modes.
0 Fast slew rate is configured on the corresponding pin, if the pin is configured as a digital output.
1 Slow slew rate is configured on the corresponding pin, if the pin is configured as a digital output.
1
PE
Pull Enable
This bit is read only for pins that do not support a configurable pull resistor. Refer to the Chapter of Signal
Multiplexing and Signal Descriptions for the pins that support a configurable pull resistor.
Pull configuration is valid in all digital pin muxing modes.
0 Internal pullup or pulldown resistor is not enabled on the corresponding pin.
1 Internal pullup or pulldown resistor is enabled on the corresponding pin, if the pin is configured as a
digital input.
0
PS
Pull Select
This bit is read only for pins that do not support a configurable pull resistor direction.
Pull configuration is valid in all digital pin muxing modes.
0 Internal pulldown resistor is enabled on the corresponding pin, if the corresponding Port Pull Enable
field is set.
1 Internal pullup resistor is enabled on the corresponding pin, if the corresponding Port Pull Enable field
is set.
11.5.2 Global Pin Control Low Register (PORTx_GPCLR)
Only 32-bit writes are supported to this register.
Address: Base address + 80h offset
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0 0
W
GPWE GPWD
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
PORTx_GPCLR field descriptions
Field Description
31–16
GPWE
Global Pin Write Enable
Selects which Pin Control Registers (15 through 0) bits [15:0] update with the value in GPWD.
Table continues on the next page...
Chapter 11 Port control and interrupts (PORT)
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
Freescale Semiconductor, Inc. 185
To Next Page
Loading...
