NXP Semiconductors KL25 Series - Modes of Operation

41.1.2 Modes of operation
The following table depicts different modes of operation and the behavior of the GPIO
module in these modes.
Table 41-1. Modes of operation
Modes of operation Description
Run The GPIO module operates normally.
Wait The GPIO module operates normally.
Stop The GPIO module is disabled.
Debug The GPIO module operates normally.
41.1.3 GPIO signal descriptions
Table 41-2. GPIO signal descriptions
GPIO signal descriptions Description I/O
PORTA31–PORTA0 General-purpose input/output I/O
PORTB31–PORTB0 General-purpose input/output I/O
PORTC31–PORTC0 General-purpose input/output I/O
PORTD31–PORTD0 General-purpose input/output I/O
PORTE31–PORTE0 General-purpose input/output I/O
NOTE
Not all pins within each port are implemented on each device.
See the chapter on signal multiplexing for the number of GPIO
ports available in the device.
Introduction
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
772 Freescale Semiconductor, Inc.