The bus clock, bus clock divided by two, and ADACK are available as conversion clock
sources while in Wait mode. The use of ALTCLK as the conversion clock source in Wait
is dependent on the definition of ALTCLK for this MCU. See the Chip Configuration
information on ALTCLK specific to this MCU.
If the compare and hardware averaging functions are disabled, a conversion complete
event sets SC1n[COCO] and generates an ADC interrupt to wake the MCU from Wait
mode if the respective ADC interrupt is enabled, that is, when SC1n[AIEN]=1. If the
hardware averaging function is enabled, SC1n[COCO] will set, and generate an interrupt
if enabled, when the selected number of conversions are completed. If the compare
function is enabled, SC1n[COCO] will set, and generate an interrupt if enabled, only if
the compare conditions are met. If a single conversion is selected and the compare trigger
is not met, the ADC will return to its idle state and cannot wake the MCU from Wait
mode unless a new conversion is initiated by the hardware trigger.
28.4.10 MCU Normal Stop mode operation
Stop mode is a low-power consumption Standby mode during which most or all clock
sources on the MCU are disabled.
28.4.10.1 Normal Stop mode with ADACK disabled
If the asynchronous clock, ADACK, is not selected as the conversion clock, executing a
stop instruction aborts the current conversion and places the ADC in its Idle state. The
contents of the ADC registers, including Rn, are unaffected by Normal Stop mode. After
exiting from Normal Stop mode, a software or hardware trigger is required to resume
conversions.
28.4.10.2 Normal Stop mode with ADACK enabled
If ADACK is selected as the conversion clock, the ADC continues operation during
Normal Stop mode. See the chip configuration chapter for configuration information for
this MCU.
If a conversion is in progress when the MCU enters Normal Stop mode, it continues until
completion. Conversions can be initiated while the MCU is in Normal Stop mode by
means of the hardware trigger or if continuous conversions are enabled.
Functional description
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
498 Freescale Semiconductor, Inc.
To Next Page
Loading...
