Table 30-24. Modes of operation (continued)
Modes of operation Description
Stop mode
If enabled, the DAC module continues to operate
in Normal Stop mode and the output voltage will
hold the value before stop.
In low-power stop modes, the DAC is fully
shut down.
NOTE
The assignment of module modes to core modes is chip-
specific. For module-to-core mode assignments, see the chapter
that describes how modules are configured.
Chapter 30 12-bit Digital-to-Analog Converter (DAC)
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
Freescale Semiconductor, Inc. 545
To Next Page
Loading...
