NXP Semiconductors KL25 Series - MCG Control 7 Register (MCG_C7)

MCG_ATCVL field descriptions
Field Description
7–0
ATCVL
ATM Compare Value Low
Values are used by Auto Trim Machine to compare and adjust Internal Reference trim values during ATM
SAR conversion.
24.3.11 MCG Control 7 Register (MCG_C7)
Address: 4006_4000h base + Ch offset = 4006_400Ch
Bit 7 6 5 4 3 2 1 0
Read 0 0 0
Write
Reset
0 0 0 0 0 0 0 0
MCG_C7 field descriptions
Field Description
7–6
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
5–1
Reserved
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
0
Reserved
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
24.3.12 MCG Control 8 Register (MCG_C8)
Address: 4006_4000h base + Dh offset = 4006_400Dh
Bit 7 6 5 4 3 2 1 0
Read 0
LOLRE
0 0 0
Write
Reset
1 0 0 0 0 0 0 0
MCG_C8 field descriptions
Field Description
7
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
6
LOLRE
PLL Loss of Lock Reset Enable
Determines if a interrupt or a reset request is made following a PLL loss of lock.
Table continues on the next page...
Memory Map/Register Definition
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
382 Freescale Semiconductor, Inc.