EasyManua.ls Logo

NXP Semiconductors KL25 Series - Page 189

NXP Semiconductors KL25 Series
807 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
During Stop mode, the interrupt status flag for any enabled interrupt is asynchronously
set if the required level or edge is detected. This also generates an asynchronous wakeup
signal to exit the Low-Power mode.
Chapter 11 Port control and interrupts (PORT)
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
Freescale Semiconductor, Inc. 189

Table of Contents

Related product manuals