To Next Page

To Previous Page

Model 4200A

-SCS Parameter Analyzer Reference Manual Appendix D: Using a Model 82 C-

V System

4200A-901-01 Rev. C / February 2017 D-43

The return values from status can be:

• 0: OK.

• -10000 (INVAL_INST_ID): The specified instrument ID does not exist

• -10001 (INVAL_PIN_SPEC): An invalid DUT pin number was specified

• -10003 (NO_SWITCH_MATRIX): No switch matrix was found

• -10004 (NO_MATRIX_CARDS): No matrix cards were found

• -10020 (COMP_FILE_ACCESS_ERR): There was an error accessing the specified cable

compensation file

• -10021 (COMP_FILE_NOT_EXIST): The specified compensation file does not exist

• -10022 (KI590_NOT_IN_KCON): There is no CMTR defined in your system configuration

• -10090 (GPIB_ERROR_OCCURRED): A GPIB communications error occurred

• -10100 (INVAL_PARAM): An invalid input parameter is specified

If CabCompFile does not exist, or if there is no path specified (null string), the default compensation

parameters are used. When entering the path, be sure to use two \ characters to separate each

directory. For example, if your cable file is in:

C:\calfiles\590cal.dat

You would enter:

C:\\calfiles\\590cal.dat

If you are controlling a switch matrix to route signals using a connection UTM (for example,

“connect”), you do not need connect InputPin and OutputPin. Set these parameters to 0.

Also see

None

Keithley 4200A-SCS Reference Manual

Other manuals for Keithley 4200A-SCS