Keithley 4200A-SCS

In this appendix:
Micromanipulator 8860 prober software .................................. H-1
Probe station configuration ...................................................... H-2
Probesites Clarius project example ....................................... H-17
Probesubsites Clarius project example ................................. H-23
Commands and error symbols .............................................. H-27
Micromanipulator 8860 prober software
You need to have the following software programs on the Micromanipulator 8860 to configure and
operate the 8860 prober with the Keithley Instruments 4200A-SCS:
• pcBridge: Used to configure the communications setup (icon on the desktop)
• pcLaunch: Used to launch various wafer controls and utilities (icon on the desktop)
• pcIndie: Used to probe multi-subsites per die (button in pcLaunch window)
• pcWafer: Used to probe single subsites per die (button in pcLaunch window)
• pcNav
• pcRouter
pcIndie and pcWafer, which are not included with standard prober software, are required. Refer to
the prober manufacturer, Micromanipulator, for availability.
Appendix H
Using a Micromanipulator 8860 Prober