-SCS Parameter Analyzer Reference Manual Section 13:
LPT library function reference
4200A-901-01 Rev. C / February 2017 13-15
The 4225-PMU or 4220-PGU returns to the following states:
• The pulse mode is maintained. For example, if the pulse card is in Segment Arb mode, it will still
be in Segment Arb mode after the devint process is complete.
• 5 V and 10 mA ranges
• If in pulse mode:
 Period of 1 µs
 Transition Times (Rise and Fall) of 100 ns
 Width of 500 ns
 Voltage high and low of 0 V
 Load of 50 Ω
• If in segmented arb mode, Start Voltage is 0 V
• If in arbitrary waveform mode, Table Length is 100
Also see
clrcon (on page 13-199)
clrscn (on page 13-9)
clrtrg (on page 13-11)
dev_abort (on page 13-92)
devclr (on page 13-67)
kibdefint (on page 13-24)
disable
This command stops the timer and sets the time value to zero (0).
Usage
int disable(int instr_id);
The instrument identification code of the timer module (TIMERn)
Details
Timer reading is also stopped.
Sending disable(TIMERn) stops the timer and resets the time value to zero (0).
Also see
enable (on page 13-16)
To Next Page
Loading...
Need help?
General
