D: Using a Model 82 C-V System Model 4200A-SCS Parameter Analyzer
D-36 4200A-901-01 Rev. C / February 2017
Procedure
1. If set, you are prompted to open the circuit so that an offset capacitance measurement can be
made.
2. If a cable compensation file is specified, the compensation information in that file for the selected
range and frequency will be loaded. If not, instrument default compensation is used.
3. A C-t sweep is performed.
Also see
None
DisplayCableCompCaps82 user module
This user module is used for Model 82 cable compensation. When this test is run, the nominal
capacitance source values saved by the SaveCableCompCaps82 user module are placed into a
spreadsheet for viewing.
Usage
status = DisplayCableCompCaps82(char *CabCompFile, double *Range, int RangeSize,
double *Values100 k, int Values100 kSize, double *Values1M, int Values1MSize);
Returned values are placed in the Analyze sheet; see Details
The complete name and path for the cable compensation file; see
Output; an 8-element array that receives the nominal range values
The size of the Range array; set to 8
Output; an 8-element (fixed) array that receives the nominal capacitor values used
for the cable compensation at the 100 kHz frequency
Values100k
Output; an 8-element (fixed) array that receives the nominal capacitor values used
for the cable compensation at the 1 MHz frequency
The size of the Values1M array; set to 8
To Next Page
Loading...
Need help?
General
