Keithley 4200A-SCS

Section
8: Keithley User Library Tool (KULT) Model 4200A-SCS Parameter Analyzer
Reference Manual
8-50 4200A-901-01 Rev. C / February 2017
Options
You can place any of the following options at the [options] position in the command:
• -dep <library_dep_1>...[library_dep_6]
Specifies up to six libraries on which library_name depends.
• -hide
Hides library_name so that it is not visible in Clarius.
• +hide
Shows library_name so that it is visible in Clarius.
Example
Update the KI590ulib library in the active user-library directory, which depends on the Winulib
library:
C:\>kultupdate KI590ulib -dep Winulib
Copying user libraries using kultcopy
The kultcopy utility copies any user library from any accessible storage location to the active user-
library directory. kultcopy:
• Copies the user library that is specified by the "Start-In" user-library directory, which is the
directory in which you start the kultcopy command.
To successfully copy a user library to the active user-library directory, you must start kultcopy in
the following directory:
<source_lib_path>\<source_lib_name>\src
This directory is called the "Start-In" directory, where:
 <source_lib_path> is any accessible user-library directory.
 <source_lib_name> is the name of the specific user library to be copied.
• Performs kultupdate so that the user library is immediately ready for use (refer to Updating
user libraries using kultupdate (on page 8-49)).
Usage
kultcopy <library_name> [options]
Options
Any of the following options may be placed at the [options] position in the command:
• -dep <library_dep_1>...[library_dep_6]
Specifies up to six libraries on which library_name depends.
• -hide
Hides library_name so that it is not visible in Clarius.
• +hide
Shows library_name so that it is visible in Clarius.