The V24/1 module is an underequipped variant with only one V.24 interface.
Interface
Figure 3-63 V24 interfaces (S30807-Q6916-Xxxx)
Note
You must configure the CDRC (call detail recording, central) device on interface X2 in OfficeCom
and OfficePoint when using a V24/2 module.
Pin assignment
Figure 3-64 V24 pin assignment in OfficeCom/OfficePoint
3.4.11 V24 adapter
The V.24 adapter cable is used for connecting PCs directly to Hicom 150 E OfficeOne. Level
adaptation is provided by an additional electronic unit in the cable. V.24 operation is not possible
without level adaptation.
Variously wired adapters are implemented between the cable's 9-pole Sub-D socket and the interface
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_33.htm (13 of 16) [06/04/2000 13:04:11]
To Next Page
Loading...
