Siemens Hicom 150 E Office - Callback in Idle or Busy State; Distinctive Ringing in the Network

Check the feature for error-free functioning as follows:
Step Action
1. Call a networked and busy extension.
2. If internal camp-on is enabled in this extension, the extension will receive a camp-on signal.
7.11.9 Distinctive Ringing in the Network
Definition
The calls are analysed and signalled accordingly within the network.
CorNet N calls are treated and signalled in the same way as internal calls.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x _ _
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 _ _
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Call a networked extension.
2. The networked extension receives the same call signalling as for an internal call.
7.11.10 Callback in Idle or Busy State
Definition
The 150 E Office callback feature can also be activated throughout the entire PABX. The user
interface is the same as that for an internal callback. The extension number of the networked
extension is stored and displayed instead of the internal extension.
Model-Specific Data
Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (10 of 17) [06/04/2000 13:11:33]