8.10 Configuring Call Management with group call
and call forwarding - no answer
Introduction
Call Management allows you to configure group calls with call forwarding - no answer. In order for
this to be possible, extensions must be assigned to the appropriate group. This group is assigned one
entry each for referencing to a specific index in the call forwarding - no answer table for day service
and night service and for internal traffic. The sequence for call forwarding - no answer is defined in
this table.
Example
During day service, external calls for extension number 450 are first to be signalled at all extensions
in group 350 (extensions 250, 251, 252); after 4 rings, they are to be forwarded to extension 300.
Programming with Hicom Assistant T
Step Entry Action Display
1. *95 31994 Start system administration System Administration
2. 16-15-1 Select Group Grp 350, Mbr 1: -
3.
*250
Enter extension 250 Grp 350, Mbr 1: 250
4.
+ *251
Enter extension 251 Grp 350, Mbr 2: 251
5.
+ *252
Enter extension 252 Grp 350, Mbr 3: 252
6. F7 F7 18 Select CM-Elements CM-Elements
7. 1 Select CM-Targets List 1, Mbr 1: called
8.
#29
Select destination list 29* List 29, Mbr 1: called
9.
+ *300
Enter extension 300 as 2nd member List 29, Mbr 2: 300
10. F7 18-3 Select Extern. Calls, Day Call No. 200: 30
11.
#450
Select call number 450 Call No. 450: 30
12.
*29
Enter list 29 for call no. 450 Call No. 450: 29
13. F7-5 Select the number of call cycles for list 1: 3
14.
#29
Select list 29 for list 29: 3
Hicom 150 E Office Rel.1.0 Service Manual - 8.10 Configuring Call Management with group call and call forwarding - no answer
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_810.htm (1 of 2) [06/04/2000 13:12:38]
To Next Page
Loading...
