Siemens Hicom 150 E Office - Deferring a Call

7.2.33 Deferring a call
Definition
While an incoming call is being signalled at an extension, the called party can set up an outgoing
connection without answering the incoming call.
The waiting call is then signalled as a "camped-on" call.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements Digital subs./port module _
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
General requirements optiset E with display
Dependencies/Limitations
Subject Dependency/Limitation
Deferring the call Line keys or at least 2 call keys must be programmed on the terminal.
Deferring the call One of the appropriate keys must be available in order to execute the feature.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure key
*91 => Entry to key programming.
2. Press relevant key.
3. Assign the feature `Call key?' or `Line key?' to the selected key.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure key
Options
2. Set up station => Key programming
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (46 of 48) [06/04/2000 13:10:00]