CorNet-N CorNet-N is treated in the same way as an internal call.
Group call If one or more extensions in a group call are free, the call will be offered to
them. The other group members do not receive an indication. If all extensions
are busy, all of them receive the camp-on signal.
Voice calling Voice calling to busy extensions is not possible.
Recall Recalls of external calls that cannot be signalled because of their low priority are
intercepted.
Recall Displaced internal calls are released.
Silent camp-on The camp-on tone can be deactivated for external calls by means of a procedure.
This does not affect display signalling.
Configuration options
The feature can be configured using:
Hicom Assistant E
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Options
2. Systems Parameters
3. Tones and ring types
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Camp-on: (internal calls, CorNet-N)
If the internal called extension is busy, the calling party first hears a busy signal. Five seconds
later, the busy party receives a display message indicating that a call is waiting, and the
camp-on tone is activated. The calling party hears the busy signal change to a ring tone. The
busy party can answer the call with the "answer call waiting" feature.
2. Ring injection: (external calls)
If a call is placed to a busy internal extension from the public network, the busy party
immediately receives a message indicating that a call is waiting. Any ISDN information sent
(CLIP) is displayed on the screen if the calling party has enabled this feature.
7.2.3 Call Management (CM)
Definition
The call management feature is used to determine how incoming calls are to be handled depending on
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (3 of 48) [06/04/2000 13:09:57]
To Next Page
Loading...
