4.2.8 Performing a visual inspection
A visual inspection of the hardware, cables and power supply is to be performed before the system is
started up. The visual inspection must be performed when the system is in energised state.
Caution
Ensure that the system is earthed and disconnected from the power supply before
commencing workgeerdet und .
The antistatic wristband must always be worn and the measures for protecting
electrostatically sensitive devices (see Page 1-5) must be observed.
Step Action Tools/remarks Possible remedies
1. Compare the slots for the
existing boards with the
component mounting
diagram.
Component mounting diagram for
boards
Correct board configuration
and notify appropriate sales
department.
2. Check the local supply
voltage.
Digital multimeter
You can begin to start up the system as described in Section 5.2 once the visual inspection
has been completed.
| Siemens | Home | First Page | Previous Page | Next Page | Search | Info | Help |
© Siemens AG, München, 1998
Hicom 150 E Office Rel.1.0 Service Manual, 2, 1998-06-26
Siemens Part No.: P31003-M1530-X403-2-7620
Conversion Date: 1998-09-18
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4fc.htm (9 of 9) [06/04/2000 13:04:51]
To Next Page
Loading...
