Siemens Hicom 150 E Office - Configuring Least Cost Routing (DICS)

8.24 Configuring Least Cost Routing (DICS)
Introduction
An optiset E memory is required for programming the LCR with Assistant T.
Example
A DICS server is used.
The trunks are laid in route 1.
All numbers with a prefix are routed as extensions via the DICS, local calls are routed via the
primary carrier as normal.
Programming with Hicom Assistant T
Step Entry Action Display
1. *95 31994 Start system administration System Administration
2. 35-8-1 Enter selected digits Line 1: -
3.
* 0-0Z
Enter extensions that are to be routed
via DICS
Line 1: 0-0Z
4. Confirm Next Line 2: -
5.
* 0-Z
Other numbers are not routed Line 2: 0-Z
6. F7 Back to dialling plan
7. 2 Allocate path table Line 1: 0
8.
* 1
Configure path table for routed
number
Line 1: 1
9. Confirm Next Line 2: -
10.
* 2
Configure path table for the
remaining digits
Line 2: 2
11. F7 Return to dialling plan Dialling plan
12. F7 Return to least cost routing Least Cost Routing
13. 7 Configure path tables Path tables
14. 1 Configure route for routed digits Tab 1, Line 1: 0
15.
* 1
Enter route Tab 1, Line 1: 1
16. Confirm Next Tab 1, Line 2: 0
Hicom 150 E Office Rel.1.0 Service Manual - 8.24 Configuring Least Cost Routing (DICS)
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_824.htm (1 of 3) [06/04/2000 13:13:33]