Siemens Hicom 150 E Office - Radio Paging Equipment (PSE); Single-Call Radio Paging Equipment

SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Direct answer When the code *96 is selected, the microphone is automatically activated
for each "voice call". This function is deactivated by selecting #96 again.
Do not disturb If the extension has activated "do not disturb", it cannot be called.
Shuttle, enquiry,
transfer
Shuttle, enquiry and transfer are not possible.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Dial a terminal using the code *80 or a "voice calling" key + internal destination extension
number (destination must be an optiset E terminal with a speaker or a speaker group)
2. The destination extension receives an alerting tone and the speaker is activated.
7.8.7 Radio Paging Equipment (PSE)
Definition
Depending on the type, radio paging equipment can be used to transmit voice calls or alphanumeric
data (message texts) to extensions with portable radio receivers. The user being paged for can answer
this call from any telephone extension by means of a procedure.
Radio paging equipment can be connected via analog a/b interfaces, analog trunk circuits or a special
board (TMOM for enhanced radio paging equipment - for OfficePro only). Two variants are
available:
Single-call radio paging equipment
Enhanced radio paging equipment (OfficePro with TMOM only)
7.8.7.1 Single-Call Radio Paging Equipment
Definition
Single-call radio paging equipment supports voice calls and the transmission of numeric data to paged
subscribers. The paged subscriber is informed of a waiting call by one of the two message variants.
The user being looked for can now answer this call from any terminal by means of a procedure.
The radio paging equipment can be a call forwarding or answer group destination. It can also be a
Hicom 150 E Office Rel.1.0 Service Manual - 7.8 Features for internal traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (8 of 17) [06/04/2000 13:11:10]