Siemens Hicom 150 E Office - Upgrading from Hicom 150 E to Hicom 150 E Officepro

Do not connect the cable between Hicom 150 E OfficePro and Hicom GCM until the call
charge computer/manager has been configured.
Assignment of the connecting cable S30267-Z35-A ...
Figure 6-7 Assignment of the connecting cable S30267-Z35-A ...
Output formats
For information about the output formats (compressed, uncompressed) for call detail recording
central, see Section 7.12.8.
6.1.5 Upgrading from Hicom 150 E to Hicom 150 E OfficePro
Introduction
The following notes on upgrading from Hicom 150 E Rel. 1.0/2.0/2.1 to Hicom 150 E OfficePro Rel.
1.0 must be observed.
If Then
Upgrading to
OfficePro
single cabinet
Note distribution of the PCM sequence in Figure 4-20.
Upgrading to
OfficePro
two-cabinet
system
Note the following points:
Position of the connecting cable between the cabinets
(Figure 4-12)
Distribution of the PCM sequence in Figure 4-21.
Hicom 150 E Office Rel.1.0 Service Manual - 6 Expanding the system
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6m.htm (13 of 14) [06/04/2000 13:05:06]