Siemens Hicom 150 E Office - Setting up a Two-Cabinet System (Side by Side)

2. Attach the base elements to the metal housing of the cabinet by inserting two screws per
element into the existing holes in the housing (2).
3. Proceed with the installation of the system.
Mounting the base elements
Figure 4-3 Hicom 150 E OfficePro - mounting the base elements using a three-cabinet system as an
example
4.1.6.5 Setting up a two-cabinet system (side by side)
Procedure
Step Action
1. Remove the front and rear cabinet covers.
2. Place the system cabinets side by side in the installation site and make sure that they are level
and stable. Correct any differences in height.
3. Attach the two cabinets using four connecting plates and two screws with washers each
(Figure 4-4).
It is important to ensure that the connecting plates are mounted in the correct direction (facing
inside!).
Installing a two-cabinet system
Hicom 150 E Office Rel.1.0 Service Manual - 4 Installation
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4m.htm (7 of 27) [06/04/2000 13:04:41]