Siemens Hicom 150 E Office - CFW with Rerouting

Station number
suppression
The call number/name display can be activated/deactivated from each extension
with the station number suppression function.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure names/numbers
*9531994
2. 19-16 => Display Text Menu - Names / Numbers
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure names/numbers
Options
2. System Parameters
3. Display
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Call a networked extension.
2. Depending on the configuration, the name or the number is displayed.
7.11.12 CFW with Rerouting
Definition
When a call is forwarded via CorNet N, `rerouting' can be implemented to optimise use of the B
channel.
Extension A from PABX 1 calls extension B in PABX 2. Extension B initiated CFW to extension C in
PABX 1. Both B channels between PABX 1 and 2 are released. This means that the connection takes
place immediately in PABX 1. A prerequisite is that `rerouting' is active in both PABXs.
Model-Specific Data
Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (12 of 17) [06/04/2000 13:11:34]