Siemens Hicom 150 E Office - 5 Start-Up; Hicom 150 E Officepro Start-Up; Hicom 150 E Officepro; Start-Up Procedure

5 Start-up
5.1 Hicom 150 E OfficePro start-up
5.1.1 Overview
Chapter contents
This chapter contains information on how to start up the Hicom 150 E OfficePro communication
system.
Danger
Only authorized service personnel should carry out the system start-up.
5.1.2 Start-up procedure
Table 5-1 Hicom 150 E OfficePro - start-up procedure
Step Start-up activity (notes)
1. Supplying the system with power
(Plugging in the power cable of the power supply unit(s) -> starting the system
boot)
page 5-2
2. Carrying out the country initialisation page 5-7
3. Entering the route tel. number page 5-9
4. Performing customer-specific system programming page 5-10
5. Carrying out a quick check page 5-10
5.1.3 Supplying the system with power
Procedure
Step Action
1. Plug in the power cable of the power supply unit(s).
Hicom 150 E Office Rel.1.0 Service Manual - 5 Start-up
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_5m.htm (1 of 7) [06/04/2000 13:06:35]