Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1.
2.
7.4.3 Line Keys
Definition
You can program line keys on the optiset E terminal on a B channel basis. This enables you to answer
or seize the line by pressing the line key directly. The LED signals the line status.
LED Meaning
off Line is free
continuously lit Line is busy
flashing rapidly Incoming call / recall
flashing slowly Line is on hold
flickering Line in `camp-on' mode; call at own station
You can use line keys to implement the following features:
Call pickup
Retrieve line on exclusive hold
Retrieve line on exclusive hold
Answer calls
Shuttle between several different lines
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements U
P0/E
- terminals
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (4 of 10) [06/04/2000 13:10:14]
To Next Page
Loading...
