Siemens Hicom 150 E Office - Collect Protection Per CO Line

To Next Page

To Previous Page

2. Trunk modules

3. Announcement equipment

Performing Feature Check

Check the feature for error-free functioning as follows:

Step Action

7.5.11 Collect protection per CO Line

Definition

This feature enables incoming reverse charge calls to be released automatically. Each analog trunk

(loop start) can be configured individually. If the feature has been released for an analog trunk, 1 s

(default value) after an incoming call has been answered, the loop is opened for 2 s (default value).

This enables reverse charge calls to be released in the network, other calls are not affected by this.

Model-Specific Data

Subject OfficePro OfficeCom OfficePoint OfficeOne

Feature available in x - - -

HW requirements analog

trunk line

(loop start)

- - -

SW requirements As of Rel. 1.0 - - -

Dependencies/Limitations

Subject Dependency/Limitation

Collect protection per CO line

Only available in Brazil. The setting is ignored in all other countries.

Configuration options

The feature can be configured using:

Hicom Assistant T / Hicom Assistant E

Programming Feature Via Hicom Assistant T

Configure the feature via Hicom Assistant T as follows:

Step Action

Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (17 of 18) [06/04/2000 13:10:28]

Other manuals for Siemens Hicom 150 E Office