Siemens Hicom 150 E Office - Brief Description; Brief Overview; LAN Bridge Connection

Connection to printer/modem/PC: connect 9-pin Sub D socket (female) to the printer/modem/PC.
Consult the operating instructions provided by the manufacturer before starting up a
printer/modems/PC.
For information on output formats (compressed, uncompressed) for call detail recording,
central see Section 7.12.8.
6.2.2 LAN Bridge connection
6.2.2.1 Brief description
LAN Bridge is an expansion board for Hicom 150 E OfficeCom/OfficePoint. It is used for connecting
a "local" LAN to OfficeCom/OfficePoint and for linking up to "external" LANs via the system's ISDN
interfaces.
Telematic and CTI functions are also supported.
The connection to the "local" LAN is set up either via an Ethernet twisted-pair interface (RJ 45
connector) or an Ethernet AUI interface
1
(Sub-D 15-pin). The connection to the system is set up with
the 50-pin edge connector of any expansion port in OfficeCom.
A separate V.24 interface is available for loading and administrative purposes.
Note
The LAN Bridge connection to OfficePoint is set up using the STLS board in slot 5.
6.2.2.2 Brief overview
Hicom 150 E OfficeCom/OfficePoint and LAN Bridge.
Service Layout
Telematic services (vCAPI) Group 3 fax machine, outgoing traffic*
Group 3 fax machine, incoming traffic with DID*
File transfer (e.g. Eurofiletransfer)
Telephony services (CTI) Dialling aid
Call log
Administration LAN Bridge administration
LAN types Ethernet, twisted pair interface, AUI interface
LAN-LAN coupling
Remote LAN Access
PPP: point-to-point log
IP routing (compatible with market standard)
IPX routing
Router functions Central firewall
Short hold mode
Channel bundling as required, configurable
Broadcast filtering
* only one incoming or outgoing transfer at a time
Hicom 150 E Office Rel.1.0 Service Manual -
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6fc.htm (2 of 11) [06/04/2000 13:07:52]