Siemens Hicom 150 E Office - Optiset E Adapters

9.2.2 optiset E adapters
9.2.2.1 Overview
Introduction
The following equipment can be used with terminals in the optiset E family:
Add-on device (AOD): optiset E key module, mounted on the side
Various adapters (mounted on the bottom of the device, see Figure 9-6).
Caution
Always disconnect the telephone line cord before connecting adapters/add-on devices.
Installing the optiset E adapter
Figure 9-6 Installing an adapter on the bottom of the device, sockets
Documentation
As a general rule, the user sets up the optiset E terminals and installs the adapters. If necessary, please
refer to the following publications:
Service instructions for optiset E terminals (see List of documentation)
Installation instructions for optiset E adapters, included with each adapter.
9.2.2.2 optiset E key module
Hicom 150 E Office Rel.1.0 Service Manual - 9 Terminals
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_9.htm (9 of 17) [06/04/2000 13:06:13]