Siemens Hicom 150 E Office - LAN Bridge Integration

Figure 6-14 Bus topology
6.2.2.8 LAN Bridge integration
Requirements for integration
Free slot
1 LAN Bridge per OfficeCom/OfficePoint
OfficeCom/OfficePoint starting from SW Version 1.0
ISDN trunk connection
One of the three interfaces described above
One LAN Bridge per system is supported. There are no plans for special country variants.
200 logical subscriber ports
60 logical lines
Procedure for integration
Step Action
1. Remove the power plug (deactivate UPSC if applicable)
2. Insert the board
3. Insert the power plug (activate UPSC if applicable)
This sequence must be observed to guarantee successful LAN board login.
6.2.2.9 Start-up
Hicom 150 E Office Rel.1.0 Service Manual -
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6fc.htm (7 of 11) [06/04/2000 13:07:52]